HP Rack Series
Rack Intelligent Series rack
HP 636 1075mm Pallet Intelligent Series Rack
BW895A
HP 636 1075mm Shock Intelligent Series Rack
BW896A
HP 642 1075mm Pallet Intelligent Series Rack
BW903A
HP 642 1075mm Shock Intelligent Series Rack
BW904A
HP 647 1075mm Pallet Intelligent Series Rack
BW911A
HP 647 1075mm Shock Intelligent Series Rack
BW912A
NOTE:
Please see the QuickSpecs for additional information:
http://h18000.www1.hp.com/products/quickspecs/14223_div/14223_div.html
(Worldwide)
NOTE:
The increasing power of new high-performance processor technology requires
increased cooling efficiency for rack-mounted servers. The 10000 G2 Series Racks
provide enhanced airflow for maximum cooling, allowing these racks to be fully loaded
with servers using the latest processors.
CAUTION:
If a third-party rack is used, observe the following additional requirements to
ensure adequate airflow and to prevent damage to the equipment: Front and rear
doors: If your 42U server rack includes closing front and rear doors, you must allow
5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to
permit adequate airflow (equivalent to the required 64 percent open area for
ventilation). Side: The clearance between the installed rack component and the side
panels of the rack must be a minimum of 7 cm (2.75 inches).
CAUTION:
Always use blanking panels to fill all remaining empty front panel U-spaces in
the rack. This arrangement ensures proper airflow. Using a rack without blanking
panels results in improper cooling that can lead to thermal damage.
NOTE:
Quick deploy rail system provides tool-free support for racks with square or
round mounting holes (including Compaq/HP 7000, 9000, 10000 G2 and HP series), with
an adjustment range of 24" - 36". The ambidextrous cable management arm can be
mounted on either the left or right side for improved cable management.
NOTE:
High Airflow Inserts (High Air Flow Rack Door Insert for the 7142 Rack (single) -
PN: 327281-B21; or High Air Flow Rack Door Insert for the 7142 Rack (6-pack) - PN:
327281-B22) are required to support the HP ProLiant DL160 in 7000 series racks. Cable
Management Arm is not supported on 7000 series racks.
NOTE:
Cable management arm must be removed to access power supplies when the
cable management arm is mounted on the right.
HP Rack Options
HP Location Discovery Services
HP 36U Location Discovery Kit
BW945A
HP 42U Location Discovery Kit
BW946A
HP 47U Location Discovery Kit
BW947A
NOTE:
Please see the QuickSpecs for Technical Specifications and additional
information:
http://h18000.www1.hp.com/products/quickspecs/14429_div/14429_div.html
(Worldwide)
HP USB Keyboard and Mouse
HP USB BFR with PVC Free US Keyboard/Mouse Kit
631341-B21
QuickSpecs
HP ProLiant DL160 Generation 8 (Gen8)
Additional Options
DA - 14282 Worldwide — Version 22 — December 13, 2013
Page 41
To Next Page
Loading...
