HP ProLiant DL160 - Page 57

HP Ethernet 1Gb 2-port
361i Adapter
Network Interface 10Base-T/100Base-TX/1000Base-TX
Capability IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
IEEE 1588, IEEE 802.1AS
Data Transfer Method PCI Express v 2.1, 5.0 GT/s and 2.5 GT/s bus speeds and supports for x1, x2,
x4 links widths (Lanes)
Controller I350 Powerville
Network Transfer Rate 10Base-T (Half-Duplex) 10 Mb/s per port, 20 Mb/s Combined
10Base-T (Full-Duplex) 20 Mb/s per port, 40 Mb/S Combined
100Base-TX (Half-Duplex) 100 Mb/s per port, 200 Mb/s Combined
100Base-TX (Full-Duplex) 200 Mb/s per port, 400 Mb/s Combined
1000Base-TX (Half and
Full-Duplex)
1000Mb/s per port, 2000 Mb/s Combined
Connector RJ-45
Cable Support 10Base-T Categories 3, 4 or 5 UTP; up to 328 ft (100 m)
10/100/1000Base-TX Category 5 UTP; up to 328 ft (100 m)
HP Dynamic Smart Array
B120i Controller
Dimensions Embedded
Disk Drive and Enclosure
Interface - Transfer rate
Up to 6Gb/s SATA (Serial ATA)
Connectors 6 internal SATA connectors
Server Interface x4 PCIe 2.0
SATA Speed 6Gb/s SATA links
Cache Memory Zero Memory RAID has no cache memory
Logical Drives Supported Up to 8 logical volumes (6 physical drives)
Host Memory Addressing 64-bit, supporting greater than 4GB server memory space
Hot Plug Support Yes
RAID Support RAID 0 (Striping), RAID 1 (Mirroring)
RAID 1+0 (Striping & Mirroring)
QuickSpecs
HP ProLiant DL160 Generation 8 (Gen8)
Technical Specifications
DA - 14282 Worldwide — Version 22 — December 13, 2013 Page 57