Removal and replacement procedures 41
Optional hard drive backplane assembly (top)
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the hard drives from hard drive bays 5, 6, 7, and 8 ("SAS and SATA hard drive" on page
29).
5. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 36).
6. Remove the air baffle ("Air baffle" on page 37).
7. Remove all fan modules ("Fan module" on page 34).
8. Remove the fan blank ("Fan blank" on page 35).
9. Disconnect the hard drive data cable and the hard drive power cable from the optional hard drive
backplane and the system board ("Hard drive backplane cabling" on page 57).
10. Remove the optional hard drive backplane.
To replace the component, reverse the removal procedure.
Standard hard drive backplane assembly (bottom)
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Remove all hard drives ("SAS and SATA hard drive" on page 29).
5. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 36).
6. Remove the air baffle ("Air baffle" on page 37).
7. Remove all fan modules ("Fan module" on page 34).
To Next Page
Loading...
