Removal and replacement procedures 45
3. Install the heatsink.
4. Install the air baffle ("Air baffle" on page 37).
5. Install the BBWC battery pack, if removed ("BBWC battery pack" on page 36).
6. Install the access panel ("Access panel" on page 27).
7. Slide the server into the rack.
Processor
The server supports single- and dual-processor operation. Fan 2 is only required when processor 2 is
installed in the server. When only one processor is installed, always install the fan blank.
CAUTION: To prevent possible server malfunction, do not mix processors of different speeds or
cache sizes. Refer to the label on the processor heatsink for a description of the processor.
To Next Page
Loading...
