OS Support
Microsoft Windows NT® Server
Microsoft Windows 2000
Windows Server 2003
Novell NetWare
Linux (Red Hat, SuSE)
NOTE:
For a more complete and up-to-date listing of supported OSs and versions, please visit our
OS Support Matrix page at:
http://www.hp.com/go/supportos
.
NOTE:
For a listing of the latest drivers available for the ProLiant DL360, please see:
http://h18023.www1.hp.com/support/files/server/us/index.html
.
NOTE:
For a more complete and up-to-date information on Linux support, please visit HP Linux
Web site at
http://h18000.www1.hp.com/products/servers/linux/hpLinuxcert.html
.
NOTE:
For more complete and up-to-date information on how to buy server operating systems
from HP please visit the OS product site at:
http://h18004.www1.hp.com/products/servers/software/OEM.html
Rack Airflow
Requirements
Rack 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 Series Racks provide enhanced airflow for
maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION:
If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors
:
If your 42U server rack includes closing front and rear doors, you must
allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to
permit adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side:
The clearance between the installed rack component and the side panels of the rack
must be a minimum of 2.75 inches (7 cm).
CAUTION:
Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
cooling that can lead to thermal damage.
NOTE:
For additional information, refer to the Setup and Installation Guide or the Documentation
CD provided with the server, or to the server documentation located in the Support section at the
following URL:
http://h18000.www1.hp.com/products/servers/proliantdl360/index.html
.
HP Factory Express
Capabilities
HP Factory Express gives you the flexibility to choose from a full menu of factory capabilities all in
one manufacturing facility, in one process, with one touch giving you full control and access to
HP's World class manufacturing facility anytime. This approach provides you the speed to deploy
your IT needs, with total quality assurance, reliability, and predictability to lower your total cost of
ownership by letting HP install, rack, and customize your software and hardware options for you.
QuickSpecs
HP ProLiant DL360 Generation 3
Standard Features
DA - 11504 Worldwide QuickSpecs — Version 38 — 12.13.2004
Page 6
To Next Page
Loading...
Need help?
General
