Removal and replacement procedures 16
4.
Use a Torx T-10 screwdriver to remove the locking screw.
5. Remove the diskette drive blank.
To replace the component, reverse the removal procedure.
Diskette drive
1. Power down the server ("Powering down the server" on page 11).
2. Extend the server from the rack. ("Extending the server from the rack" on page 11)
3. Remove one of the following from the left hard drive bay:
• Hard drive blank (on page 13)
• Hard drive (on page 14)
4. Use a Torx T-10 screwdriver to remove the locking screw.
5. Remove the diskette drive.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
