Removal and replacement procedures 17
Optical device blank
IMPORTANT: The ejector button is recessed to prevent accidental ejection; it may be helpful to use a pen
or similar shaped object to access the button.
1. Press the ejector button.
2. Remove the optical device blank.
To replace the blank, slide the blank into the bay until it locks into place.
Optical device
1. Power down the server ("Powering down the server" on page 11).
IMPORTANT: The ejector button is recessed to prevent accidental ejection; it may be helpful to use a pen
or similar shaped object to access the button.
2. Press the ejector button.
To Next Page
Loading...
