Removal and replacement procedures 21
5.
Remove the component from the server.
To replace the component, reverse the removal procedure.
Optical device and diskette drive interface
1. Power down the server ("Powering down the server" on page 11).
2. Remove all hard drives and hard drive blanks ("Hard drive" on page 14).
3. Eject the optical device ("Optical device" on page 17).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 11).
5. Remove the access panel ("Removing the access panel" on page 13).
6. Remove the diskette drive ("Diskette drive" on page 16).
7. Disconnect the cable from the optical device and diskette drive interface board.
8. Use a T-15 Torx screwdriver to remove the two screws securing the board to the server chassis.
9. Slide the board toward the front edge of the server, lift up, then slide the board toward the rear of
the server to remove the component.
To Next Page
Loading...
