Removal and replacement procedures 25
2.
Remove any expansion board installed in the assembly.
To replace the component, reverse the removal procedure.
PCI riser board
1. Remove the PCI Riser Board Assembly ("PCI riser board assembly" on page 23).
2. Remove any expansion board installed in the assembly ("PCI-X or PCI Express expansion board" on
page 24).
3. Remove the applicable PCI riser boards from the assembly:
IMPORTANT: When removing the two parts of the riser board, pay attention to the orientation of the slots
on each side. This information is important for subsequent procedures.
a. Remove the riser board with the slot for full-length expansion boards.
b. Repeat the previous step for the riser board with the slot for half-length expansion boards, if
needed.
To Next Page
Loading...
