Removal and replacement procedures 26
To replace the component, reverse the removal procedure.
Power converter module
1. Power down the server ("Powering down the server" on page 11).
2. Remove all hot-plug power supplies ("Hot-plug AC power supply" on page 19).
3. Extend or remove the server from the rack ("Extending the server from the rack" on page 11).
4. Remove the access panel ("Removing the access panel" on page 13).
5. Disconnect all internal power cables.
6. Remove the fan module ("Processor fan assembly" on page 20).
7. Slide the power converter module toward the back of the server, then lift the power converter module
from the server.
NOTE: Cables are removed for clarity.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
