Removal and replacement procedures 31
Remove the drive blank.
To replace the component, slide the component into the bay until it clicks.
Hot-plug drive
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug drive LED definitions (on page 87).
2. Back up all server data on the drive.
3. Remove the drive.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
