Hardware options installation 38
3.
Install the drive.
4. Determine the status of the drive from the drive LED definitions.
Rear drive cage options
The server supports a two-bay LFF or SFF rear drive cage option. When a rear drive cage option is installed,
the optical drive is disabled.
Installing a 2 LFF rear drive cage option
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 23).
5. Remove the rear LFF drive cage blank.
To Next Page
Loading...
