HP ProLiant DL380e Gen8 - Page 42

Hardware options installation 42
15.
Install the server into the rack ("Installing the server into the rack" on page 33).
16. Power up the server (on page 20).
Installing a 2 SFF rear drive cage option
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 23).
5. Remove the rear LFF drive cage blank.