Hardware options installation 45
c.
Connect the SATA cable to the rear drive cage, secure the cable in the cable clip, and then connect
the cable to the system board.
d. Install the primary PCI riser cage.
e. To continue with the installation procedure, go to step 13.
11. Connect the longer SATA and sideband signal cables to the front drive cage backplane:
a. Connect the SATA and sideband signal cables to the rear drive cage.
b. Route the cables along the side of the system board toward the front chassis.
c. Connect the cables to the front drive cage backplane.
To Next Page
Loading...
