Hardware options installation 53
For more information on capacitor pack cabling in different drive configurations, see "Capacitor pack
cabling (on page 99)."
9. Install the capacitor pack.
10. Install the PCI riser cage ("Install the PCI riser cages" on page 26).
11. Install the access panel (on page 23).
12. Install the server into the rack ("Installing the server into the rack" on page 33).
13. Power up the server (on page 20).
Optical drive option
To install the component:
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 23).
To Next Page
Loading...
