Removal and replacement procedures 47
9.
Remove the hard drive cage.
To replace the component, reverse the removal procedure.
Systems Insight Display
To remove the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 27) or remove ("Remove the server from the rack" on
page 28) the server from the rack.
4. Remove the access panel ("Access panel" on page 32).
5. Remove the air baffle ("Air baffle" on page 33).
6. Remove the fan cage ("Fan cage" on page 44).
7. Remove the Systems Insight Display:
a. Remove the screw from the rear of the Systems Insight Display.
b. Disconnect the Systems Insight Display cable and the USB cable from the system board, and
disconnect the USB cable from the front of the Systems Insight Display.
To Next Page
Loading...
