Removal and replacement procedures 38
CAUTION: To help avoid damage to the processor and system board, do not install the
processor without using the processor installation tool.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
IMPORTANT: When either optional I/O expansion board is installed in a two-processor
configuration, processor 2 and the I/O enabler must be installed.
To remove the component:
1. Power down the server (on page 26).
2. Remove the tray (on page 30).
3. Remove the heatsink.
4. Open the processor retaining latch and the processor socket retaining bracket.
To Next Page
Loading...
