Removal and replacement procedures 58
To replace the component, reverse the removal procedure.
Expansion slot cover
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all expansion slots have either an expansion slot cover or an expansion board
installed.
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 27).
3. Remove the access panel (on page 28).
4. Open the latch, and remove the expansion slot cover.
To replace the component, reverse the removal procedure.
Non-hot-plug expansion board
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all expansion slots have either an expansion slot cover or an expansion board
installed.
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 27).
3. Remove the access panel (on page 28).
To Next Page
Loading...
