HP ProLiant ML110 G1 User Manual

NOTE:
ThedefaultloginfortheWebUIisadministrator and
the password is hpinvent. The WebUI uses the same
login as the local administrator's account or an account
with administrative privileges.
5.
Go to Rapid Startup Wiz ard configuration,page26,tocomplete
the setup procedures.
Figure 1 Rapid S tartup Wizard window
Method 2: Direct attach
You can access the WebUI using a monitor, mouse, and keyboard directly
attached to the storage server.
1. Connect the Ethernet cable to the network port of the storage server
and the corresponding network segment.
2. Connect the monitor, mouse, and keyboard directly to the rear panel
connectors of the storage server.
3. Power on the storage server.
4. Log into the device using the WebUI user name and password.
HPProLiantStorageServeruserguide
25

HP ProLiant ML110 G1 Specifications

General

Form Factor	Tower
Processor	Intel Pentium 4
Power Supply	300W
Drive Bays	4 x 3.5"
RAID Support	Optional RAID 0, 1
Network Interface	1 x 10/100/1000 Mbps Ethernet
Operating System Support	Red Hat Linux
Expansion Slots	6 (2 x PCI-X, 4 x PCI)