To Next Page

To Previous Page

Removal and replacement procedures 55

System battery replacement warnings

Observe the following reminders when replacing the system battery:

• Replace the battery with the same type as the battery recommended by HP. Use of another

battery may present a risk of fire or explosion.

• A risk of fire and chemical burn exists if the battery is not handled properly. Do not disassemble,

crush, puncture, or short external contacts, or expose the battery to temperatures higher than

60°C (140°F).

• Do not dispose of used battery in water or fire. Dispose of used batteries according to

manufacturer's instructions.

• Loss of BIOS settings occurs when the battery is removed. BIOS settings must be reconfigured

whenever the battery is replaced.

To replace the system battery:

1. Perform the pre-installation procedure.

2. Lay the server on its side (components showing).

3. If necessary, remove any accessory boards or cables that prevent access to the battery socket.

4. Locate the system battery.

5. Replace the system battery.

a. Squeeze the metal clamp that extends above one edge of the battery until the battery pops

up (1).

b. Lift up the old battery to remove it (2).

Other manuals for HP ProLiant ML110 Generation 5

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML110 Generation 5 and is the answer not in the manual?

General

Processor Sockets	1
Chipset	Intel 3200
Memory	Up to 8 GB DDR2
Memory Slots	4
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon 3000 Sequence
Storage	Up to 4 SATA drives
Network	Embedded NC105i PCI Express Gigabit Server Adapter
Power Supply	365W
Optical Drive	Optional DVD-ROM or DVD+/-RW
Expansion Slots	1 PCIe x16, 2 PCIe x1, 1 PCI