Diagnostic tools 67
To remove the supervisor password:
1. In the Security menu screen, select the Set Supervisor Password field, and then press Enter.
2. Type the original password then press Enter.
3. Press Enter twice without entering anything in the new and confirm password fields.
4. Press F10 to save the changes you made and close the Setup Utility.
The Supervisor Password Is field value is set to Clear.
To reset the supervisor password:
If you forget the supervisor password, you need to clear the CMOS and reset the BIOS settings to
regain access the Setup Utility. For instructions, refer to the
“Clearing CMOS” section on page 70.
Boot menu
Use this menu to set the preferred drive sequence in which the Setup Utility attempts to boot the
operating system.
By default, the server searches for boot devices in the following order:
• CD-ROM/DVD-ROM drive
• Removable device
• Hard drive
• Embedded NIC (via Preboot Execution Environment—remote boot over LAN)
To implement the PXE boot option, you need to first set the Embedded NIC2 PXE field to Enabled.
Phoenix BIOS Setup Utility
Main Advanced Security Boot Exit
Item Specific Help
CD-ROM/DVD-ROM
Removable Devices
+Hard Drive
Embedded NIC
Embedded NIC1 PXE ; [Enabled]
<Tab>, <Shift-Tab>, or
<Enter> selects field
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
To Next Page
Loading...
