HP ProLiant ML110 Quickspecs

HP 4 Internal Port SAS
Host Bus Adapter
(SAS/SATA HP Model)
SATA Protocol SATA 1.5Gb/s
SATA Ports 4 internal
Port transfer rate 1.5 Gb/s total
Maximum Capacity up to 3 TB (4 x 750GB non hot plug SATA HDD)
RAID Levels Supported RAID 1 (Mirroring)
RAID 0 (Striping)
Logical RAID Volumes
Supported
2
Dimensions
(excluding bracket)
6.6 x 2.5 x 0.6 in (16.8 x 6.4 x 1.6 cm)
Disk Drive and
Enclosure Protocol
Support
3 Gbps SAS (Serial Attached SCSI)
1.5 Gbps SATA (Serial Advanced Technology Attachment)
Architecture 64-bit
SAS Connectors 1 internal SFF8484 x4 Wide SAS Connectors
12 Gbps per x4 Wide SAS Port (4 x 3 Gbps)
Data Transfer Method PCI-Express x8 - 2 GB/s maximum bandwidth
PCI Bus Speed PCI-Express x8
Simultaneous Drive
Transfer Ports
1 x4 Wide SAS Connectors
Port Transfer Rate 12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Software upgradeable
Firmware
Yes
Maximum Capacity 1.2TB (4 x 300GB)
Memory Addressing 64-bit, supporting servers memory greater than 4 GB
Logical Drives
Supported
Up to 2 Logical Volumes
Up to 10 drives total in all RAID volumes
Up to 2 Drives per RAID 1
Up to 4 Drives per RAID 0
RAID Support RAID 1 (Mirroring)
RAID 0 (Striping)
Upgradeable Firmware 4-MB flashable ROM
Disk Drive and
Enclosure Protocol
Support
3 Gbps SAS and 1.5 Gbps SATA
QuickSpecs
HP ProLiant ML110 Generation 5
Technical Specifications
DA - 12867 Worldwide QuickSpecs — Version 10 — 4.18.2008 Page 25

HP ProLiant ML110 Specifications

General

Product Line	ProLiant
Server Type	Tower
Processor	Intel Xeon E3-1200 series
Chipset	Intel C202
Memory Slots	4
Storage	SATA Hard Drives (HDDs) or Solid State Drives (SSDs)
Drive Bays	4 LFF or 8 SFF
RAID Support	RAID 0, 1, 10
Form Factor	Tower
Management	HP iLO
Operating System Support	Windows Server, Linux, VMware
Memory	DDR3 or DDR4 ECC Unbuffered DIMMs (UDIMMs) (depending on the specific generation)