HP ProLiant ML150 Installation Sheet

HP ProLiant ML150
Generation 5 Server
Installation Sheet
Configuring the server
Refer to the HP ProLiant ML150 Generation 5 Server Support CD
contents for additional information and updates not provided in this
installation sheet.
1. Connect the keyboard, mouse, and monitor
2. To determine the BIOS version:
a. Power up the server.
b. Press the Esc key at the HP logo screen, and then press the
Pause key to halt screen movement.
c. Note the server BIOS version. Verify the server BIOS
version against the latest BIOS version listed for this server
on the HP website: http://www.hp.com
d. If necessary, update the BIOS (refer to the HP ProLiant
ML150 Generation 5 Server Maintenance and Service
Guide available on the HP website: http://www.hp.com
Identifying server components
Figure 1 Front and rear panel components
Table 1 Front and rear panel components
Item Description Item Description
1 USB 2.0 ports (2) 13 AC input connector
2 Front key lock 14 Mouse connector
3 HDD bays 1-4 15 Keyboard connector
4 HDD bays 5-8 16 VGA monitor connector
5 Optical drive bay 17 Serial port connector
6 Media eject button 18 USB 2.0 ports (4)
7 Half-height drive bays 19 NIC connector
8 System power button 20 IPMI connector (slot7)
9 System power LED 21 PCIe x8 slots (2)
10 HD activity LED 22 PCIe x4 slots (3)
11 NIC LED 23 PCI 2.3-compliant slot
12 System health LED -- --
Figure 2 System board components
Table 2 System board components
Item Description
1 Rear system fan connector
2 Auxiliary power LED
3 Power supply connector (4-pin)
4 Power supply connector (24-pin)
5 Redundant power supply connector (12-pin)
6 Processor fan connectors (2)
7 Processor 0 socket
8 Processor 1 socket
9 Power supply connector (8-pin)
10 Front panel USB 2.0 port connector
11 Internal USB 2.0 port connector
12 Thermal sensor connector
13 Front system fan connector
14 Front panel I/O connector
15 SATA connectors (6)
16 Chassis/board ID DIP switches
17 Internal USB 2.0 port connector
18 CMOS clear button
19 Battery
20 PCI 2.3-compliant slot 1 connector
21 PCIe x4 slot 2 connector
22 PCIe x4 slot 3 connector
23 PCIe x4 slot 4 connector
24 PCIe x8 slot 5 connector
25 PCIe x8 slot 6 connector
26 NMI reset button
27 IPMI slot 7 connector
Table 2 System board components
Item Description
28 DIMM slot 6C (channel 0, single rank)
29 DIMM slot 5C (channel 1, single rank)
30 DIMM slot 4B (channel 0, single/dual rank)
31 DIMM slot 3B (channel 1, single/dual rank)
32 DIMM slot 2A (channel 0, single/dual rank)
33 DIMM slot 1A (channel 1, single/dual rank)
Opening the server
CAUTION: Power down the server and remove the power
cord(s) before removing or replacing non-hot-pluggable
hard disk drives, DIMMs, or processors.
If necessary, unlock the server with the supplied key.
Figure 3 Removing the access panel
Figure 4 Removing the front bezel
Part number: 457547-002
May 2008 Second edition

HP ProLiant ML150 Specifications

General

Tcase	72.8 °C
Bus type	QPI
Stepping	R2
FSB Parity	No
Scalability	2S
Processor cache	15 MB
Processor cores	6
Processor model	E5-2603V3
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2600 v3
Processor socket	LGA 2011-v3
Processor codename	Haswell
Motherboard chipset	Intel C610
Number of QPI links	2
Processor frequency	1.6 GHz
Processor cache type	Smart Cache
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	52.5 x 45 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
ECC supported by processor	Yes
PCI Express configurations	x4, x8, x16
Supported instruction sets	AVX 2.0
Thermal Design Power (TDP)	85 W
Number of processors installed	1
Physical Address Extension (PAE)	46 bit
Maximum number of PCI Express lanes	40
Memory types supported by processor	DDR4-SDRAM
Memory channels supported by processor	Quad
Memory clock speeds supported by processor	1600 MHz
Memory bandwidth supported by processor (max)	51 GB/s
Maximum internal memory supported by processor	768 GB
HDD size	- \
RAID support	-
HDD interface	Serial ATA
Total storage capacity	0 GB
Maximum storage capacity	- TB
Number of HDDs installed	0
Memory slots	16x DIMM
Internal memory	4 GB
Memory clock speed	2133 MHz
Maximum internal memory	256 GB
Memory layout (slots x size)	1 x 4 GB
Graphics card family	NVIDIA
Intel® Virtualization Technology (Intel® VT)	VT-d, VT-x
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	4
Chassis type	Rack (1U)
Power supply	550 W
Processor ARK ID	83349
Intel Secure Key Technology version	1.00
Intel Identity Protection Technology version	0.00
PCI Express slots version	3.0

Weight and Dimensions

Depth	620 mm
Width	200 mm
Height	432.6 mm
Weight	22230 g