HP ProLiant ML150 G3 User Manual

HP ProLiant Lights-Out 100 Remote Management
User Guide
For HP ProLiant ML110 G4, ML115 G1, DL140 G3, DL145 G3, and ML150 G3 Servers
Part Number 419106-008
October 2008 (Eighth Edition)

HP ProLiant ML150 G3 Specifications

General

Processor Sockets	2
Chipset	Intel 5000P
Memory Slots	8
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon 5000/5100 series, Intel Pentium D
Memory	Up to 16 GB DDR2
Storage	SAS or SATA
Network	Embedded NC373i Multifunction Gigabit Network Adapter
Expansion Slots	6 total: (2) PCI-E x8, (1) PCI-E x4, (3) PCI-X

Summary

Installation of the HP Lights-Out 100c Remote Management Card

Preinstallation procedures

Details essential steps to perform before installing the remote management card.

Installing the remote management card

Step-by-step instructions for physically installing the remote management card.

Post-installation procedures

Configuration

Configuring network access

Guides on setting up network connectivity for the LO100 via Ethernet.

Configuring user accounts

Accessing BIOS Setup Utility and using function keys

Enabling serial access to the LO100

Configuring the LO100 serial port

Using TCP/IP over Ethernet management port

Explains network access methods using Ethernet management ports.

Selecting an Ethernet management port

Guidance on choosing between dedicated or shared Ethernet ports for management.

Obtaining a DHCP IP address from the BIOS Setup Utility

How to retrieve the IP address assigned by DHCP via the BIOS.

Setting up a static IP address from the BIOS Setup Utility

Procedures for configuring a fixed IP address through the BIOS.

Enabling telnet and HTTP services

Updating the firmware

Remotely updating the firmware

Instructions for updating the LO100 firmware remotely using TFTP or CLP.

Using LO100

Using CLP

CLP syntax

Details the command structure, verbs, targets, and options for CLP.