Removal and replacement procedures 38
CAUTION: Heatsink retaining screws should be tightened in diagonally opposite pairs (in an "X" pattern).
4. Connect the fan cable to the system board.
5. Install the air baffle.
6. Install the access panel.
7. Install the bezel.
PCI expansion board
To remove the component:
1. Power down the server (on page 25).
2. Remove the bezel (on page 25).
3. Remove the access panel ("Access panel" on page 26).
4. Remove the expansion board.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
