HP Proliant ML350 Generation 3 - Page 21

Removal and Replacement Procedures
Bezel Door (Tower Model Only)
To remove the bezel door:
1. Complete the preparation procedures. Refer to “Preparation Procedures” earlier in this
chapter.
2. If the keylock is locked, unlock the bezel door using the included key (1).
3. Open the bezel door fully to the right (2).
4. Lift the bezel door and then pull it away from the chassis (3).
1
2
3
Figure 2-1: Removing the bezel door (tower model only)
To replace the bezel door, reverse steps 3 and 4.
2-6 HP ProLiant ML350 Generation 3 Server Maintenance and Service Guide