HP Proliant ML350 Generation 3 - Page 41

Removal and Replacement Procedures
To replace removable media devices, other than HP StorageWorks AIT or SDLT tape drives,
insert the device into the bay until it clicks into place.
CAUTION: Install all other options and blanks prior to installing the tape drive.
CAUTION: If you are replacing HP StorageWorks AIT or SDLT tape drives, be sure to
replace the left rear mounting screw with a Torx T-8 drive screw. Failure to do so prevents
proper installation and can damage the tape drive.
NOTE: It is not necessary to push up on the drivelock when installing a removable media device.
To replace HP StorageWorks AIT or SDLT tape drives:
1. Replace the left rear mounting screw with a Torx T-8 drive screw, included in the tape
drive kit.
2. Insert the device into the bay until the device clicks into place.
1
2
Figure 2-23: Replacing the tape drive
2-26 HP ProLiant ML350 Generation 3 Server Maintenance and Service Guide