HP ProLiant ML350 Generation 4 - Page 77

77
Server Cabling
In This Section
Cabling Guidelines .......................................................................................................................77
SCSI Hot-Plug Cabling ................................................................................................................77
Non-Hot-Plug SCSI Cabling ........................................................................................................88
Connecting ATA or ATAPI Devices to the Integrated IDE Controller........................................88
Cabling Guidelines
This chapter provides an overview of the internal cabling of the HP ProLiant
ML350 Generation 4 server chassis. It also includes information on how to cable
SCSI, IDE, and removable media devices in the system, as well as information
about all critical system cabling. If external cabling is required, refer to the
documentation included with the external storage device.
SCSI Hot-Plug Cabling
Storage Device Installation (on page 77)
Identifying SCSI Components (on page 78
)
Installing an Internal-to-External SCSI Controller ("Connecting ATA or ATAPI
Devices to the Integrated IDE Controller" on page 88
)
Cabling SmartArray or other RAID Controller ("Installing an Internal-to-
External SCSI Connector" on page 85
)
Cabling SCSI Devices in the Removable Media Area (on page 87
)
Storage Device Installation Guidelines
Consider the following guidelines when adding SCSI devices: