HP ProLiant ML350 Generation 4p Maintenance And Service Guide

Removal and replacement procedures 17
WARNING: To reduce the risk of personal injury, be
careful when pressing the server rail-release latches and sliding
the server into the rack. The sliding rails could pinch your fingers.
3. After performing the installation or maintenance procedure, slide the server
back into the rack:
a. Press the server rail-release latches and slide the server fully into rack.
b. Secure the server by tightening the thumbscrews.
Removing access panel
CAUTION: Due to the high capacitance in the power supply,
please wait 30 seconds after removing the power cable before opening
the access panel.
To remove the component:
1.
Power down the server ("Powering down the server" on page 16).
2. Do one of the following:
a.
Remove the server from the rack, if applicable ("Removing the server
from the rack
" on page 18).
b. Remove the tower front bezel, if applicable.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X