Removal and replacement procedures 31
5.
Repeat the steps above to remove the other rail.
To replace the component, reverse the removal procedure.
Power supply blank
Remove the blank from the bay.
To replace the component, reverse the removal procedure.
Hot-plug power supply
WARNING: To reduce the risk of electric shock, do not disassemble the power supply or attempt
to repair it. Replace it only with the specified spare part.
CAUTION: Do not attempt to remove and replace a power supply as a hot-plug procedure unless
both bays are populated with power supplies.
To remove the component:
1. Disconnect the power cord from the AC source.
2. Disconnect the power cord from the power supply.
To Next Page
Loading...
