Hardware options installation 80
14.
Connect the Mini-SAS cables to the drive cage backplane.
15. Connect the Mini-SAS cables to the Smart Array controller.
16. Connect the power cable that came with the RPS option kit (HP part number 676745-001), from the
optional drive cage backplane to the RPS backplane connector ("Redundant power supply backplane
connectors" on page 20).
17. Install the fan cage ("Remove the fan cage" on page 31).
18. Install the full-length PCI cards that were removed.
19. Install the system air baffle (on page 30).
20. Install the PCI air baffle (on page 29), if removed.
21. For tower models, do the following:
a. Install the access panel (on page 26).
b. Return the server to an upright position.
22. For rack models, do the following:
To Next Page
Loading...
