HP ProLiant ML350p - Page 61

Hardware options installation 61
b.
Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel (on page 22).
5. For rack models, do the following:
a. Extend the server from the rack (on page 23).
b. Remove the access panel (on page 22).
c. Release thumbscrews and remove the rack bezel.
6. Remove the blank from the drive cage.
7. Install the optical drive into the drive cage.
8. Remove the air baffle.
9. Remove the fan cage (on page 26).