Removal and replacement procedures 47
o
Extend the server from the rack (on page 29).
3. Remove the access panel ("Access panel" on page 31).
4. Press the HP Systems Insight Display ejector button to extend the HP Systems Insight Display.
5. Disconnect the Systems Insight Display cable from the system board ("System board components" on
page 82).
6. Remove two T-10 screws on the side of the Systems Insight Display.
7. Remove the Systems Insight Display.
To replace the component, reverse the removal procedure.
Memory boards and FBDIMMs
The server utilizes two memory boards. Each memory board consists of eight slots, numbered sequentially.
The paired banks are identified by the letters A through D. Each memory board supports 2x1 interleaving.
To Next Page
Loading...
