reference guide
quick start
7
Review the table below to become familiar with the front-panel status lights that
provide information about tasks that are currently being performed by your
HP PSC.
In addition to providing information about current tasks, the lights on the front
panel may also indicate error conditions, as described in the table below.
If the On light, Check Print Cartridge light, Check Paper light, and Start Copy,
Black and Start Copy, Color lights are all flashing, do the following:
1 Verify that the front-panel overlay is attached to the HP PSC.
2 Power cycle your HP PSC by disconnecting the power cord and
reconnecting.
On/Resume
Check Paper
Cancel
Check Print Cartridge
On light
(green)
Black Copy
Area
(backlight)
Color Copy
Area
(backlight)
Explanation What to do?
The On light
is not
illuminated.
Light is off. Light is off. Your HP PSC is turned off. Press the On button to turn
your HP PSC on.
The On light
is illuminated.
Light is on. Light is on. Your HP PSC is turned on
and is ready for use.
Begin a scan, copy, or print
job from the front panel or
from the software.
The On light
is blinking
Light is on. Light is on. Your HP PSC is processing
a Print, Scan, or
Maintenance job.
Wait for your HP PSC to
finish processing the job.
The On light
is blinking
Light is
blinking.
Light is on. Your HP PSC is processing
a black-and-white copy
job that was started from
the front panel or the
software.
Wait for your HP PSC to
finish processing the job.
The On light
is blinking
Light is on. Light is
blinking.
Your HP PSC is processing
a color copy job that was
started from the front panel
or the software.
Wait for your HP PSC to
finish processing the job.
Blinks faster
for 3 seconds
and then
stays
illuminated.
Light is on
or blinking.
Light is on
or blinking.
Your HP PSC is busy doing
another task.
Wait for the current job to
be completed before
starting another job.
Homer.book Page 7 Monday, February 24, 2003 6:03 PM
To Next Page
Loading...