HP PSC 2210 Setup Poster

1
2
1
2
1
C8654-90179
*C8654-90179* *C8654-90179*
Attach the cover
Insert the two bottom tabs of the
cover into the slots on the unit.
Tilt the cover down and press firmly.
Make sure the tabs lock into place
and the cover is even with the unit.
Remove output tray and load paper
Use blank white paper to
prepare for print alignment.
Connect the USB cable
3
4
Connect the power cord and phone cord
5
Turn on your HP PSC
6
Insert and align the print cartridges
Lift the print carriage door up
until it catches. Wait for the print
carriage to move to the center.
Lift the blue and gray latches.
Make sure both latches are locked
into position. Close the door.
7
Install the software
Turn your Macintosh on and
wait for your Macintosh to
finish starting up. Insert the
HP PSC software CD.
Double-click the HP All-In-
One Installer icon on your
desktop.
2
Remove the bright pink tape
from the print cartridge. Do not
touch the gold-colored contacts
or retape the cartridges.
Hold the black print cartridge with the label on top as
shown. Slide the cartridge into the right (gray latch) side of
the print carriage.
Hold the color print cartridge with the label on top as
shown. Slide the cartridge into the left (blue latch) side of
the print carriage.
Press Enter to begin alignment.
After a page prints, alignment is
complete. Discard or recycle this
page.
Try your new HP PSC
8
Whats next?
Take the product tour
Use the Director
Check the reference guide for
other ways to get started with
your HP PSC.
See your box for exact contents and
system requirements. Windows users:
see other side.
Make sure you are using the
correct side of the poster.
a
b
latches
Black label (56)
Pull the end of the gray latch toward you, press
down until it stops, and then release. Make sure
the latch catches below the bottom tabs.Repeat
with blue latch.
Follow the onscreen instructions.
You may have to restart your
Macintosh during setup. Be sure to
complete the setup assistant.
If you have an iMac, your USB port is on the side. Do
not connect the HP PSC to a USB port on a keyboard or
non-powered USB hub. See reference guide for more
details.
Note: You can adjust the viewing
angle of the display. See the
reference guide for details.
Make sure to remove any
packing material from inside
the unit.
f
a
b
a
b
a
a
b
c
d
e
b
c
d
e
f
g
g
a
b
c
a
d
Color label (57)
Macintosh setup poster hp psc 2200 series all-in-one
Be sure to insert the phone cord in the left
slot on the back of your HP PSC as shown.
To wall jack
To phone/
modem/
office equipment

HP PSC 2210 Specifications

General

Brand	HP
Model	PSC 2210
Category	All in One Printer
Language	English