additional setup information
62
hp psc 2200 series
to uninstall from a Windows computer
1
On the Windows taskbar, click Start, choose Programs or All
Programs (XP), choose Hewlett-Packard, choose hp psc 2000 series,
then choose uninstall software.
2
Follow the directions on the screen.
3
If you are asked whether you would like to remove shared files, click
No.
Other programs that use these files may not work properly if the files
are deleted.
4
After the program finishes removing the software, disconnect your
HP PSC, and restart your computer.
5
To reinstall the software, insert the HP PSC 2200 Series CD-ROM into
your computer’s CD-ROM drive, and follow the instructions that
appear.
6
After the software is installed, connect and turn on your HP PSC.
to uninstall from a Macintosh computer
1
Double-click on Applications:HP All-in-One Software folder.
2
Double-click on Uninstaller.
3
Follow the directions that appear on the screen.
4
After the program finishes removing the software, disconnect your
HP PSC, and restart your computer.
5
To re-install the software, insert the HP PSC 2200 Series CD-ROM
into your computer’s CD-ROM drive, and follow the instructions that
appear.
When re-installing the software, follow the instructions on
the Setup Poster. Do not connect the HP PSC to your
computer until after you have completed the software
installation.
To Next Page
Loading...