HP PSC 500

1-6
Setting Up Your HP PSC 500
7
Remove the black print cartridge (the thinner one) from its packaging
and, being careful to touch only the black plastic, gently remove both the
green pull tab and blue tape covering the nozzles.
8
Push the black print cartridge firmly down into the slot on the right.
9
Lower each print-cartridge latch down onto the top of the cartridge, and
push down until the latch locks firmly into place.
10
Close the print-cartridge access door.
WLSG.book Page 6 Thursday, March 9, 2000 2:26 PM