Setting Up Your HP PSC 500
Step 5 — Install the HP PSC 500 Software
Now you need to install software so that the HP PSC 500 can work with your
computer for printing and scanning.
If you are installing the software on a Windows NT 4.0 computer, you must have
Service Pack 3 or higher installed.
Windows 95/98 and NT 4.0 on the same computer), see
the Readme file on the HP PSC 500 CD-ROM for important information.
Installing the HP PSC 500 Software
Turn on your computer, but do not turn on your HP PSC 500.
If you see either of the following windows, click Cancel or press Esc on
your keyboard. Otherwise, skip to the next step.
For simple error-free installation, use the procedures in this guide to install
your HP PSC 500 software for the first time.
Click Cancel. Click Cancel.
WLSG.book Page 10 Thursday, March 9, 2000 2:26 PM
To Next Page
Loading...
