To install a secondary hard drive:
1. Install two 6–32 standard guide screws in the lower holes on each side of the drive.
NOTE: When replacing the secondary hard drive, transfer the four screws from the old drive to
the new one. You will need a Torx T-15 screwdriver to remove and re-install the guide screws. HP
has provided four extra 6-32 standard guide screws on the front of the chassis, under the front
bezel. The 6-32 standard guide screws are silver.
Figure 2-41 Installing Guide Screws in the Secondary Hard Drive
2. Align the guide screws on the secondary hard drive with the slots in the chassis, and then lower
the drive into the slots and slide the drive back until it locks in place.
Figure 2-42 Installing the Secondary Hard Drive
ENWW Installing and Removing Drives 39
To Next Page
Loading...
