3. Connect the hard drive power and data cables to the back of the secondary hard drive.
NOTE: The primary hard drive data cable must be connected to the dark blue connector labeled
SATA 0 on the system board to avoid any hard drive performance problems. Connect the other
end of the secondary hard drive data cable to the next available (unpopulated) SATA connector
on the system board in the following order: SATA 0, SATA 1, SATA 2.
Figure 2-43 Connecting the Power and Data Cables to the Secondary Hard Drive
4. Return the power supply to the down position until it locks.
5. Return the drive cage to the down position into the computer.
6. Replace the computer cover.
7. If the computer was on a stand, replace the stand.
8. Reconnect the power cord and any external devices, then turn on the computer.
9. Lock any security devices that were disengaged when the computer cover was removed.
40 Chapter 2 Hardware Upgrades ENWW
To Next Page
Loading...
