Back to TOC Troubleshooting usage and maintaining 99
To install the new ADF window
1 Position the four Z-shaped hooks of the ADF window into the four
holes on the bottom of the ADF.
2 Rotate the ADF window back until it contacts the bottom of
the ADF.
3 Check that the long, pointed tab is on the inside of the ADF.
4 Beginning with the Z-shaped hook closest to the long, pointed tab,
push each of the Z-shaped hooks toward the back of the ADF.
5 Verify that the long, pointed tab is on the inside of the ADF.
6 Reconnect the ADF cable to its port on the scanner.
To Next Page
Loading...