5. Close the scanner lid, and then raise the scanner input tray until it is perpendicular to the
scanner.
6. Press in on the ADF duplex background tabs to release the ADF duplex background, and then
pull forward to remove the ADF duplex background from its housing.
7. Wipe the ADF duplex background with a soft, lint-free cloth that has been moistened with warm
water.
8. Dry the ADF duplex background with a dry, soft, lint-free cloth, and then slide the component
into its housing until it clicks into place.
9. Lower the scanner input tray into place, and then reconnect the USB cable and power supply to
the scanner.
Clean the scanner glass, scanning strip, and automatic document feeder (ADF) duplex
background
23
To Next Page
Loading...