Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
IPSec Specify the IPSec status on the Jetdirect server.
Keep: IPSec or firewall status remains the same as
currently configured.
Disable (default): IPSec or firewall operation on the
Jetdirect server is disabled.
802.1X Reset 802.1X settings to factory defaults.
Reset: Reset 802.1X settings to factory defaults.
Keep (default): Retain current 802.1X settings.
Reset Security Specify whether the current security settings on the
Jetdirect server will be saved or reset to factory
defaults.
Yes: Security settings are reset to factory defaults.
No (default): The current security settings are
maintained.
Diagnostics Embedded Tests LAN HW Test Yes: Run a LAN hardware test.
No (default): Do not run a LAN hardware test.
HTTP Test Yes: Run an HTTP test.
No (default): Do not run an HTTP test.
SNMP Test Yes: Run an SNMP test.
No (default): Do not run an SNMP test.
Data Path Test Yes: Run a data path test.
No (default): Do not run data path test.
Select All Tests Yes: Select all tests.
No (default): Do not select all tests.
Execution Time (M) Set the time delay, in minutes, for test execution.
When you click Execute, the selected tests will execute
after this interval. Valid values are 0–24, default is 1.
Execute Yes: Execute the selected tests..
No (default): Do not execute the selected tests.
Ping Test Dest Type Select the destination type for this test.
IPV4 (default)
IPV6
Dest IPv4 Enter the IP address for the IPv4 destination.
Dest IPv6 Enter the IP address for the IPv6 destination.
Packet Size Specify the packet size for this test. Valid values are
64–2048, default is 64.
Basic configuration using the Administration menu
19
To Next Page
Loading...
