5. Close the scanning lid, and then raise the scan input tray until it is perpendicular to the product.
6. Press in on the ADF duplex background tabs to release the ADF duplex background, and then pull
forward to remove the ADF duplex background from its housing.
7. Wipe the scanning strip on the ADF duplex background with a soft, lint-free cloth that has been
moistened with warm water.
8. Dry the ADF duplex background with a dry, soft, lint-free cloth, and then slide the component into
its housing until it clicks into place.
9. Lower the scan input tray into place, and then reconnect the power supply to the product.
10. Press the Power button to turn on the product.
54 Chapter 7 Maintain the product
To Next Page
Loading...
