HP ThinState
The HP ThinState Capture tool is a very simple wizard-based tool that you can use to capture an HP
thin client WES 2009 image, which you can then deploy to another HP thin client of identical model
and hardware.
What do you need to have?
●
An HP WES 2009-based thin client that contains the latest HP-provided image
● An HP-qualified USB flash drive (Disk-On-Key). Consult the thin client quick specs for the latest
approved USB flash drives.
WARNING! By default, the First Boot Device in the F10 System BIOS is first set to USB, then ATA
Flash, and finally to Network boot. If the default Boot order settings have been changed, it is critical
before using the HP ThinState Capture tool that you first set the First Boot Device in the Advanced
BIOS Features section of the F10 System BIOS to USB.
NOTE: ThinState Capture now uses ibrpe.exe for imaging. Any flash drives previously created
containing ibr.exe can no longer be used.
HP ThinState Capture
To perform an HP ThinState capture:
1. Disable the write filter prior to launching the Thinstate Capture tool. If you do not, you will be
presented with the following warning:
26 Chapter 4 Applications ENWW
To Next Page
Loading...
Need help?
General