Securing the thin client
These thin clients are designed to accept a security cable. The security cable prevents unauthorized removal
of the thin client, as well as preventing access to the secure compartment. To order this option, go to the HP
website at http://www.hp.com and search for your specic thin client.
1. Locate the security cable slot on the back panel.
2. Insert the security cable lock into the slot, and then use the key to lock it.
NOTE: The security cable is designed to act as a deterrent, but it may not prevent the computer from being
mishandled or stolen.
Mounting and orienting the thin client
HP Quick Release
An optional Quick Release mounting bracket is available from HP for mounting the thin client to a wall, desk,
or swing arm. When the mounting bracket is used, do not install the thin client with the I/O ports oriented
towards the ground.
This thin client incorporates four mounting points on the right side of the unit. These mounting points follow
the VESA (Video Electronics Standards Association) standard, which provides industry-standard mounting
interfaces for Flat Displays (FDs), such as at panel monitors, at displays, and at TVs. The HP Quick Release
connects to the VESA-standard mounting points, allowing you to mount the thin client in a variety of
orientations.
NOTE: When mounting to a thin client, use the 10 mm screws supplied with the HP Quick Release.
Securing the thin client 9
To Next Page
Loading...
Need help?
General
