HP Thin Client T740 User Manual

5. Remove the stand from the thin client.
6. Lay the unit at on a stable surface with the right side up.
7. Remove the thin client access panel. See Removing and replacing the access panel on page 16.
WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components
to cool before you touch them.
8. Locate the USB ash drive port on the system board.
9. Align the USB ash drive with the USB port and press the drive rmly into the port until it is securely
seated.
10. Replace and latch the access panel, and then reinstall the rear I/O panel. See Removing and replacing
the access panel on page 16.
11. Replace the thin client stand.
12. Reconnect the AC power cord and turn on the thin client.
13. Lock any security devices that were disengaged when the thin client access panel was removed.
24 Chapter 3 Hardware changes

HP Thin Client T740 Specifications

General

Power	65 W external power adapter
Graphics	AMD Radeon Vega 8 Graphics
Memory	Up to 32 GB DDR4-2400 SDRAM
Networking	Optional Wi-Fi 5 (802.11ac)
Ports	2 x DisplayPort 1.2
Operating System	HP ThinPro HP Smart Zero Core Windows 10 IoT Enterprise
Dimensions	3.5 x 20 x 20 cm