11.
Grasp the print cartridge by the center handle
and remove the protective plastic shield.
NOTE: Do not touch the print cartridge roller.
Fingerprints on the roller can cause print-quality
problems.
12.
Remove the sealing tape from the print
cartridge. Place the tape in the print-cartridge
box to return for recycling.
13.
Grasp the print cartridge by the center handle
and insert the print cartridge into the product.
NOTE: Compare the color label on the print
cartridge to the color label in the carousel slot to
make sure the print cartridge color matches the
carousel position. (The black carousel position
has no label.)
CAUTION: If toner gets on your clothing,
wipe it off with a dry cloth and wash the clothing
in cold water. Hot water sets toner into the
fabric.
14.
Close the print cartridge door.
NOTE: After closing the print cartridge door,
the control panel shows the Calibrating...
message. Allow a few minutes for the product to
calibrate.
NOTE: If you need to replace another print
cartridge, you must close the print cartridge
door before touching the Cartridge Rotate
button again.
You do not need to wait for the product to
calibrate when replacing the second print
cartridge. Instead, touch the Cartridge Rotate
button to rotate the carousel into position. After
you have replaced the print cartridges, the
product calibrates.
134 Chapter 7 Manage and maintain ENWW
To Next Page
Loading...
