1. The HP Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) for all devices mounted. Because
mounting surfaces vary widely and the final mounting method and configuration may vary, mounting fasteners are not
supplied (other than the VESA-compliant screws). HP recommends that you consult with a qualified engineering,
architectural or construction professional to determine the appropriate type and quantity of mounting fasteners required
for your application and to ensure that your mounting solution is properly installed to support applied loads.
2. Service levels and response times for HP Care Pack Services may vary depending on your geographic location. Service starts
from date of hardware purchase. Restrictions and limitations apply. See www.hp.com/go/cpc for details.
3. EPEAT® Silver where HP registers commercial display products. See www.epeat.net for registration status in your country.
4. External power supplies, power cords, cables and peripherals are not Low Halogen. Service parts obtained after purchase
may not be Low Halogen.
Copyright © 2016 HP Development Company, L.P.
ENERGY STAR is a registered mark owned by the U.S. government. The information contained herein is subject to change
without notice. The only warranties for HP products are set forth in the express limited warranty statements accompanying
such products. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or
editorial errors or omissions contained herein.
To Next Page
Loading...
Need help?
General
