1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Disconnect the battery cable from the system board (see Battery on page 38).
Two solid-state drive slots are available on the computer, as shown in the following illustration. The primary
drive is on the right side of the computer near the memory modules.
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the bracket and drive to the computer.
2. Pull the drive out of the socket, and remove the drive with bracket from the computer (2).
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
